Crimp detection for fork type pre-insulated terminals

1. Use the corresponding suitable cold-pressed terminal according to the cross-section of the wire, and the corresponding specifications are required to be exactly the same.
2. The length of the stripped wire insulation layer complies with the regulations, and the length is required to be correct.
3. All metal wires of the wires are completely wrapped in the cold-pressed terminals, and no scattered copper wires are required.
4. The crimping part conforms to the regulations, and the crimping part is required to be correct.
5. The strength test after crimping is based on the strength of the tensile strength test in the TB/T1507-93 standard, referring to the attached table 3, and the calibrated TLS-S2000A spring tension and compression testing machine is used to verify the quality of the crimping.
6. Inspection of crimping tools The crimping tools must meet the requirements of the fixation strength in Schedule 3, and they must be checked every three months. The tools that meet the requirements should have labels showing their validity period.
7. Wiring bundling When bundling wiring, bundling at least once every 400~500mm.